Product Description
Linder topcoat is specially designed for textured coatings, especially suitable for indoor and outdoor textured coatings with high requirements for stain resistance and weather resistance. The use of this product not only enhances the self-cleaning and scrubbing resistance of the textured coatings, but also greatly enhances the dust-proofing, water-proofing and weather-resistant capabilities of the textured coatings. It can also make the natural color of the wall remain unchanged through wind and rain.
Product Features
Efficient waterproof
Mold and moisture resistant
Strong stain resistance
Wide range of application
Bright color enhancement
Strong weather resistance
Construction process
Construction method: spraying, roller coating
Theoretical paint consumption
Total consumption is about (10-12) square meters/kg/one coat (dry film 30 microns).
Depending on the roughness of the actual surface and the dilution ratio, the amount of paint consumed may vary.
Dilution
≤10% water dilution;
Mix well before use.
Recoating time (in terms of dry film 30 microns, 25~30℃)
Surface drying: 10 minutes -Hard drying: 30 minutes -Recoating: ≥2 hours
Substrate Requirements
The base should be solid, level, clean and dry.
Maintenance time
7 days/25℃: low temperature (should not be lower than 5℃) appropriate extension, in order to obtain the ideal paint film effect.
Construction conditions
Please do not construct in wet or cold weather (temperature <5℃, relative temperature >85%), otherwise the expected painting effect cannot be achieved.
Cleaning
When stopping in the middle of painting and after finishing, please wash all the instruments with water in time.
substrate treatment
| surface treatment | Remove surface dust, grease and loose plaster from new walls, repair any holes in time and ensure that the walls are clean, dry and level. | Repainting the wall to remove the old wall not solid paint film, remove surface dust chalk and impurities, batch leveling and sanding, clean and thoroughly dry. |
| surface state | Ensure that the surface humidity of the pre-coated substrate is <10% and the pH value is <10. | The surface of the pre-coated substrate must be firm, dry, clean, flat and free of loose material. |
Coating system and number of coats
| Painting System | primers | top coat |
| Construction method | “Linder Multi-Functional Anti-Alkali Sealing Primer” once more | Two coats of “Linder topcoat” |
Safety matters
Please be sure to read the construction instructions of the product package carefully before use, in order to obtain reliable and satisfactory painting effect;
Open all windows and doors as much as possible before starting operation and use to ensure that the construction area has sufficient ventilation;
in case of allergic skin, always wear protective gears during use; in case of inadvertent contact with eyes, rinse immediately with plenty of water; in case of inadvertent contact with skin and causing persistent pain or irritating sensation, rinse immediately with plenty of water and seek medical assistance;
Do not allow children or pets to enter the construction area and keep the product out of their reach; if accidentally contaminated with children, immediately flush with plenty of water and seek medical assistance;
Do not pour paint into sewers or drains;
dispose of paint waste in accordance with local environmental standards.
Storage
Store tightly closed in a cool and dry place at 0-40℃.
Shelf life: 24 months
